How to install the wiring of the explosion-proof high-energy igniter

How to install the explosion-proof high-energy igniter? How to wire it?

Explosion-proof higher energy ignition rod and ignition cable

1. 2520 heat-resistant alloy is developed for the front end of the ignition rod.

2. The basic ignition rod diameter is Φ16, and the external thread is M18×1.5. In special circumstances, the ignition rod diameter, length, and connection method can be customized according to customer requirements. The length of the ignition cable can also be customized according to customer satisfaction.

Installation and wiring of explosion-proof high-energy igniter

1. (1) The application site is the burner. The burner has a Φ16.5 hole and is produced and processed into M18×1.5 mounting external threads. Just screw the ignition rod in, and the tantrum end of the ignition rod is installed on the oil pump ( Air) 30-50mm in front of the mouth.

(2) If the application place is to release a torch, the ignition rod must be fixed with a special type ignition rod buckle, and the distance between the tempering end of the ignition rod is 100-200mm from the venting mouth. This ignition rod is a new structure ignition rod, no need to adjust the charge and discharge interval.

2. The ignition device of this series is composed of an explosion-proof box, a special ignition cable and an ignition rod. When installing, connect the ignition device shell and the ignition rod with a special ignition cable, the switching power supply is 380V.AC.