Introduction of 95 porcelain alumina and its thermal properties
Feb 17, 2021
Leave a message
People usually call ceramics with Al2O3 content greater than 75% as high alumina ceramics. 95 alumina porcelain is the most widely used ceramic in structural ceramics.
95 porcelain alumina
Because it has excellent electrical properties at high frequencies, its dielectric loss is small, the volume resistivity is large, the strength is high, the hardness is large, the linear expansion coefficient is small, and the wear resistance and heat resistance are also very good.
It is more economical and practical to use 95% alumina porcelain under normal circumstances. For occasions with particularly high performance requirements, 99% to 99.9% alumina porcelain is used.
Shaped alumina 95 ceramic parts
1. Average linear expansion coefficient The relative elongation of ceramics when the unit temperature is increased, that is, the average linear expansion coefficient is one of the main performance indicators of 95% alumina ceramics. According to the national standard GB/T5593-1999, the test temperature is 20-500℃, a is 6.5×10-6-7.5×10-6/℃; when the test temperature is 20-800℃, a is 6.5×10-6- 8×10-6/℃. Since ceramic parts are generally sealed with metal parts, the expansion coefficient is required to match that of the metal material.
2. Thermal shock resistance refers to the ability of ceramic materials to withstand rapid cold and rapid heat. The 95% alumina ceramic has good thermal shock resistance and can withstand the test of high temperature and rapid cold and rapid heat without damage.
The national standard GB/T5593-1999 stipulates: put 10 ceramic samples in a heating furnace at 800±10℃, after holding for 30 minutes, take them out and place them on an asbestos board, cool to room temperature naturally, and then put the samples in 800°C heating furnace.
Perform 10 times in total according to the above regulations, and finally soak in 1% magenta solution for 3 minutes, take it out and wash with tap water, wipe dry, observe the sample under the light, if there are no cracks in 10 samples, burst Phenomenon, the performance is qualified.

