Quality identification method for explosion-proof high-energy igniter
Jan 01, 2020
Leave a message
1. Connect all the wires of the igniter to the Ferrero. There is no need to connect the power cord plug (the battery charging end of the AC igniter), or unplug the high voltage output group of the magneto beforehand. After establishing a good quality connection between the ground wire of the igniter and the ground wire of the car's internal circuit, the high pressure cap is removed from the spark plug, and a spark plug that backs up data data is inserted on the car body. Finally, connect the inverter circuit on the motorcycle (the zero line of the live wire is connected to the battery + pole.) to the battery charging terminal of the igniter.
2. After connecting the high-energy igniter to the circuit as described above, turn the magneto to turn on the sensor to send an ignition signal to the igniter to see if the spark plug ignites. If the spark plug ignites, this is a DC power igniter. (The battery charging end of the AC igniter generally accepts several hundred volts working standard voltage, and ignores the 12V of the battery.) If it does not ignite temporarily, check the cause carefully, or use the meter measurement method to establish the igniter Features, can not be misjudged as AC igniter at will.
3. The way to compare commercial insurance is to use the bottom voltage power transformer for continuous inspection of the igniter. It has been established many times that the bottom piezoelectric DC power igniter is not used to distinguish it as an AC igniter. Standard car buyers can use the AC DC high-voltage power supply with a small total current flow. If it is a DC power igniter, the small total current flow = reduced working standard voltage without harming the igniter. However, the high pressure of the total flow of small electricity will continue to charge the battery of the AC igniter, so be careful when checking the battery charging.
4. For special situations, for example, inductive high-voltage coils are not suitable for service facilities CDI igniters; some are igniters combined with high-voltage coils,

