Flame Sensor
May 06, 2021
Leave a message
Function Description
The flame sensor is a sensor specially used by the robot to search for fire sources. Of course, the flame sensor can also be used to detect the brightness of the light, but this sensor is particularly sensitive to flames. The flame sensor uses the characteristic that infrared rays are very sensitive to flames, uses a special infrared receiver tube to detect the flame, and then converts the brightness of the flame into a signal of high and low changes, which is input to the central processing unit, and the central processing unit makes corresponding responses according to the changes in the signal. Program processing.
principle
Flame sensor: It is composed of high-temperature solid particles mainly composed of various combustion products, intermediates, high-temperature gases, hydrocarbons and inorganic substances. The flame radiation intensity and wavelength distribution of objects are different, but in general, the near-infrared wavelength domain and ultraviolet light domain corresponding to flame temperature have great radiation intensity, and flame sensors can be made according to this characteristic.
Far infrared flame sensor
Functional use: The far-infrared flame sensor can be used to detect fire sources or other heat sources with a wavelength in the range of 700 nanometers to 1000 nanometers. In robot competitions, the far-infrared flame detector plays a very important role. It can use the eyes of the robot to find the source of fire or football. It can be used to make fire extinguishing robots, football robots, etc.
Principle introduction: The far-infrared flame sensor can detect infrared light in the range of 700 nanometers to 1000 nanometers, and the detection angle is 60. When the infrared light wavelength is near 880 nanometers, its sensitivity reaches the maximum. The change in light intensity is converted into a change in current, which is reflected by the A/D converter as a numerical change in the range of 0~255.
UV flame sensor
Principle introduction: Through the ultraviolet light, the detection angle can be set according to the actual situation. The ultraviolet transmission visible absorption glass (filter) can detect the wavelength of 400 nanometers. The ultraviolet flame detector converts the intensity of the internal infrared light into the change of the current. Reflected by the A/D converter is the value change in the range of 0~255. The stronger the external ultraviolet light, the smaller the value; the weaker the ultraviolet light, the numerical simulation.
Instructions for use
The installation of the far infrared flame sensor is shown in the figure below. Pay attention to the following points when installing and using:
a. Remove the photosensitive sensor from the robot, and then connect the far-infrared flame sensor directly to the photosensitive interface.
b. The pins of the far-infrared flame sensor are polarized. When installing, connect the red wire to the position marked with "+" on the motherboard; if there is no response during use, just insert the sensor backwards.
c. In the graphical programming, directly use the "brightness detection module" to control; in the code frame programming, use the function and detection.
d. The working temperature of the far-infrared flame detector is -25℃~85 months. During the use, the distance between the flame detector and the flame should not be too close to avoid damage.

