How To Replace The Gas Stove Ignition Electrode

To remove the furnace of the gas stove, take it down the cover outside and make sure the above is clean, then disconnect the power to the switch, then remove the struts of the switch. Drag the gas stove, unscrew the upper screw, and remove the upper tempered glass panel after the sealing cover is opened, and then remove the old ignition device to replace the new gas stove ignition electrode.

Be careful to pick up the line, finally experiment, see if you can point to fire, if you can explain, you can use it normally, sometimes the gas stove is only a little show, we can take rust Remove, then add some lubricants, not to be replaced.

Gas stove igniter use precautions

1. Since the power battery of the igniter is mounted inside the housing, it is preferable to install the battery before installing to the cooker, and the rear cover is opened when the battery is replaced.

2. When the output voltage of the ignition is high, the hand cannot touch the discharge point of the electric electrode, so as not to touch the human body, if it is unfortunate, there will be no danger.

3, the relative distance of the discharge ignition electrode and the fire hole of the burner should be appropriate, and ensure firm, if there is loose moment, it should be adjusted in time to ensure its ignition is successful.