What To Pay Attention To When Putting In The Oil Fuel Device

Jan 08, 2020

Leave a message

What should be paid attention to when putting the oil fuel device in the initial ignition?

Answer: When the cold furnace is ignited, two oil guns should be put in at the same time to influence each other and stabilize the combustion; two oil guns are arranged at the bottom of the burner, and the oil guns should be replaced and repaired regularly so that the heated surface is heated evenly. At the initial stage of ignition, pay attention to the adjustment of the air volume and the atomization of the oil gun, always observe the flame, and judge the air volume ratio according to the flame color. If the flame is red, there is smoke from the fire hole, and the chimney emits black smoke, indicating that the air volume is insufficient, and the air volume should be increased; if the flame is bright yellow, the air volume is basically suitable; if the flame is white, the air volume is too large and needs to be reduced Air volume; if there are too many sparks, it means that the spray gun is not well atomized. If it is serious, stop using it. In addition, the oil pressure can not be too high, otherwise it will delay the fire; while the oil pressure is too low, the atomization will not be good.


Send Inquiry