Use of explosion-proof high-energy igniter
Jan 15, 2020
Leave a message
Explosion-proof high-energy igniter ignition rod and ignition cable
1. The front end material of the ignition rod is 2520 high temperature alloy.
2. The outer diameter of the conventional ignition rod is Φ16, the installation thread is M18×1.5, and the outer diameter, length, and connection method of the ignition rod can be customized according to user requirements. The length of the ignition cable can also be customized according to customer needs.
Use of explosion-proof high-energy igniter
1. Before ignition, make sure that the furnace has been purged without residual combustible gas. Prevent deflagration and other safety accidents when ignition starts.
2. When igniting, you should turn on the ignition device first, and then inject fuel (gas) to ignite.
3. When the igniter is used for fuel ignition, the fuel should be atomized well. If the atomization quality is too poor, the ignition success rate will be affected. After the ignition is completed, the ignition rod must be manually pulled out of the flame burning zone with a propeller or manually to ensure the service life of the ignition rod.
4. When the fuel is ignited, turn off the igniter. In order to avoid the burning of internal components caused by continuous ignition for a long time, a protection module has been added to the igniter. Continuous ignition for 10 seconds at a time will automatically stop the ignition output. Press the local ignition button or reconnect the remote drive to resume ignition.
5. Do not drop or touch the ignition rod when installing and using it to prevent the ignition rod insulation ceramic parts from breaking, resulting in high voltage leakage, non-ignition and other consequences, which will seriously affect the safety and normal operation of the equipment.
Guidelines for using explosion-proof high-energy igniter:
Explosion-proof high-energy igniters are mainly suitable for the ignition of industrial boilers, industrial gas and fuel oil. The emergence of high-energy igniters has changed the traditional industrial ignition mode. Traditional ignition mainly uses torches to ignite. Workers are required to approach the gas or oil pipeline to ignite. The risk factor Very high, and the explosion-proof high-energy igniter solves this method. We only need to lead the signal wire to the central control room. When it is necessary to ignite, the ignition can be completed remotely in the central control room.
The explosion-proof high-energy igniter is also due to other ignition, such as the ignition transformer. The transformer needs to touch the ionization rod to ignite, and the ionization rod outputs an electric arc, which is easy to burn out if it is exposed to the flame for a long time. The ignition rod of the high-energy igniter outputs an electric spark. No direct contact with gas or fuel pipes is required. With a temperature resistance of 1300 degrees Celsius, it is more reliable than ion bar ignition and has a longer service life.

