What are the ignition needle and induction needle of a gas water heater?

Feb 05, 2021

Leave a message

huopai23

The picture above is a fire row style of a gas water heater. We can see that there are 3 needles with white bottoms, the first two are ignition needles, and the third one without any tip and longer size is an induction needle.

    Then many friends asked, why are there two ignition needles? An ignition needle can no longer be used. I think there is a needle in the burner of a gas stove? In fact, everyone’s question is right, but the internal fire radiator of the gas water heater is very different from the gas stove. If the gas water heater is accurately controlled, it can also achieve single-needle ignition and control the distance between the ignition needle and the fire radiator. Within 4-6mm.

    When we turn on the hot water faucet, the water flow sensor starts to operate. After the single-chip microcomputer detects the water flow signal, it outputs the signal to the pulse igniter. The pulse igniter generates high voltage through the tip of the ignition needle to discharge and arc, but if the ignition needle and the fire row The ignition will not succeed if the distance is too far or too close. Therefore, in order to avoid errors, the ignition needle (the middle needle in the picture) discharges at the tip and the receiving needle (the left needle in the picture) discharges arc ignition, so that they are connected together and fixed on the fire row. Reduce the error, thus forming a double needle ignition. So what we see is that one is pointed and the other is flat.

    The sensor needle is easy to understand. In fact, it is exactly the same as the sensor needle of a gas stove. The sensor needle of a gas stove can be divided into a thermocouple and an ion sensor needle, and the gas water heater is basically an ion sensor needle. We can see that its needle body is very long. When the flame burns, the needle body is burned by the flame, and the flame can generate unidirectional conductive ions, which can be induced by the pulse igniter.

    Therefore, the function of the pulse igniter is that when the tip discharge ignition is successful, the ion needle is burned at this time, and the pulse igniter detects it, no longer discharge ignition. At the same time, if the flame is turned off midway, the microcontroller will issue an instruction to close the gas proportional valve to avoid accidents, so this is the reason why the ignition needle and the induction needle cannot be exchanged.


Send Inquiry