Installation And Wiring Of Alumina Ceramic Ignition Electrode

Jan 04, 2020

Leave a message

Installation and wiring of alumina ceramic ignition electrode

(1) The use occasion is a burner. The burner has a Φ16.5 hole and is machined into an M18×1.5 mounting thread. Just screw in the ignition rod, and the ignition end of the ignition rod is installed on the fuel (gas) nozzle The front 30-50mm.

(2) The use occasion is to disperse the torch, and the ignition rod needs to be fixed with a special ignition rod clip, and the ignition end of the ignition rod is 100-200mm from the vent. The ignition rod is a new structure ignition rod, and does not need to adjust the discharge distance.

The ignition device of this series is composed of an igniter box, a special ignition cable and an ignition rod. When installing, connect the ignition device box and the ignition rod with a special ignition cable, the power supply is 220V.AC.

The explosion-proof high-energy igniter is mainly used for the automatic ignition of gas and oil industrial burners and the ignition of flared torches. It has the advantages of reliable ignition and long life. The ignition end is resistant to high temperature, moisture and coking, and has self-cleaning ability, so it is widely used Petroleum, chemical industry, metallurgy, ceramics, environmental protection energy and other industries.


Send Inquiry