Use Of Alumina Ceramic Ignition Electrode
Jan 03, 2020
Leave a message
1. Before ignition, make sure that the furnace has been purged without residual combustible gas. Prevent deflagration and other safety accidents when ignition starts.
2. When igniting, you should turn on the ignition device first, and then inject fuel (gas) to ignite.
3. When the igniter is used for fuel ignition, the fuel should be atomized well. If the atomization quality is too poor, the ignition success rate will be affected. After the ignition is completed, the ignition rod must be manually pulled out of the flame burning zone with a propeller or manually to ensure the service life of the ignition rod.
4. When igniting the fuel, turn off the igniter. In order to avoid the burning of internal components caused by continuous ignition for a long time, a protection module has been added to the igniter. Continuous ignition for 10 seconds at a time will automatically stop the ignition output, and turn on the ignition switch to resume ignition.
5. Do not drop or touch the ignition rod when installing and using it to prevent the ignition rod insulation ceramic parts from breaking, resulting in high voltage leakage, non-ignition and other consequences, which will seriously affect the safety and normal operation of the equipment.

