Stove Spark Igniter Not Working
May 14, 2022
Leave a message
Repair the gas stove according to the cause of the damage
One, no sparks. The point system of the cooker consists of three parts: ignition needle, pulser, and battery. The main points to check are:
1. Check whether the battery is charged or not, and try to replace it with a new battery
2. When you press the knob, you can hear the "pop" pulse ignition sound, but you can't see the spark, it must be the ignition needle is broken, because the ignition needle is made of iron core outer ceramic, it is easy to break during transportation (it is the outer ceramic The layer is broken, and the whole root will not be broken), causing the break to be closer to the negative electrode and sparking below, and it can be solved by replacing the intact ignition needle of the same type;
3. If there is no "snap" sound, it may be that the connection wire of the ignition needle is not in good contact (also feels), check the connection connector to ensure that it is powered on;
4. If there is no problem with the first two points, that is, the pulser does not work. Check whether the connection between the pulser and the battery box is in good condition. If it is in good condition, then you have to replace the new pulser.
Second, there are sparks, but no fire. The main point is to make a fire, and three points must be satisfied: the suitable intensity of the spark, the suitable position of the spark hitting the air hole of the fire cover, and the suitable mixing concentration of the injected gas and air. As long as these three points are met, the fire will surely be lit. So check the following points:
1. Check whether there is air coming out, use a lighter to light the fire, or hear/smell the smell, if there is no air coming out, check whether the intake valve is open;
2. Turn the ignition needle so that the spark just hits the edge of the hole closest to it.
3. Adjust the damper, because the damper is too large and the mixing ratio of gas and air is too small, it is not easy to ignite. Turn it down first to make the gas concentration high; after ignition, adjust the damper to the blue flame, but the bottom of the flame does not leave the air hole.

