Analysis on Maintenance and Repair of Ultraviolet Flame Detector
Jan 19, 2020
Leave a message
In the process of monitoring the combustion of gas and oil, pollutants may be emitted during the combustion of gas and oil, which will make the quartz lens in the UV probe of the ultraviolet flame detector sticky and dirty, and affect the reception of the UV signal in the flame by the UV probe, resulting in sensitivity Therefore, in order to ensure the normal operation of the UV probe, the lens of the probe must be wiped from time to time (according to the usage) to keep it clean and transparent.
2. The sensitivity of the sensor will decrease at the end of its service life. Therefore, after a long period of use, if the sensitivity of the sensor is found to no longer meet the actual requirements, the UV probe should be replaced in time.
3. Can't see the flame:
(1) Check whether the power supply is normal;
(2) Check whether the connection between the probe and the module is normal;
(3) Check whether the photosensitive tube of the probe is in good condition and whether the flame being monitored is within the effective viewing angle range of the sensor. The checking method is as follows:
First observe whether the shell of the photosensitive tube is broken, and whether the internal electrode of the photosensitive tube is damaged. Under the condition of ensuring the above-mentioned intactness, replace the photosensitive tube with another good probe and check again. If it works normally, the photosensitive tube is intact Otherwise, the photosensitive tube is damaged and should be replaced in time.
Adjust the sensor angle visually so that the flame can be within the effective viewing angle range of the probe.
4. False alarm: Check whether the working power supply is too high, whether the signal line is short-circuited, and whether there are interference sources such as electric welding on site.

