Types of flame detectors
Jan 13, 2020
Leave a message
The flame detector converts the light signal into a corresponding electrical signal output through a photosensitive sensor to achieve the purpose of controlling and detecting the equipment. Its core component is a photosensitive sensor, which can be divided into infrared sensors and visible light according to the difference of induced light There are two categories of sensors.
If it is not sensitive or too sensitive, you should consider replacing it with a new detector, and also pay attention to whether your burner has light leakage, and plug all abnormal light sources.
UV flame detector
Mainly used for flame monitoring of gas and oil industrial burners
Troubleshooting
1. The burner has no fire, but the monitor shows fire. This is the interference caused by the gradual increase of the distributed capacitance after the monitoring line is damp. Please turn on the module and slowly adjust the sensitivity adjustment potentiometer on the upper left of the module counterclockwise until the green and red indication When the light is off and the relay is released, the monitor can be adjusted.
2. The burner is on fire, but the monitor shows no fire. There may be two reasons. One is that the lens of the probe is covered by dust. Please clean the quartz lens of the probe. The other is that the sensitivity adjustment potentiometer is over-adjusted. Adjust the sensitivity adjustment potentiometer until the green indicator light is on and the relay is closed.

